Uncategorized
Showing all 19 results
-
Uncategorized
Earth Spike HDG 1.2m (incl Clamp)
The galvanised earth spike or stake is used to earth the electric fence system. A minimum of 3 earth spikes must be knock into the ground near the electric fence at a minimum of 1.5 m apart. Connect these earth spikes to the energizer or the fence using the high tension insulated cable (HT). In areas where earthing conditions are bad you may be required to add a few more earth spikes/stakes along the fence line and connect these back to the energiser.Features:
• Hot-dip galvanised with nuts and washers
• Available in both 1.0m and 1.2m lengths
• The double nut and washer allow for a good electrical connection with the HT cablesEarthing kit available, to be used in areas where the earthing conditions are poor. These kits include a conductive earth compound (EA-CEC)
Specifications
Finish: Hot dip galvanised
Lengths: 10mm x 1.2mSKU: n/a -
Uncategorized
Fence Light Timed S/Steel Blue
Features
Indicates power on the fence for peace of mind
• Visible from up to 1km at night and 100m during the day
• No batteries required
• Uses minimal power from the fence
• The frequency of the flashing LEDs indicates the amount of energy on the fence. The longer the period between flashes, the lower the voltage on the fence
• Highly visible LEDs allow for a 160-degree viewing angle. This allows the light to shine into the secure area only
• Can operate from 0.9kV to 12kV
• Can be used with most electric fence energizersSpecifications
Material: Plastic and water tight compound
Steel wire connectors: Galvanised (Brown housing) or stainless steel (Blue housing) option
Waterproof Housing IP66
Flashing rates:
1. Flashing normally rate over ~7.5kV
2. Flashing at 25% slower than normal between 7.5kV~3kV
3. Flashing at 50% slower than normal between 3kV~2.5kV
4. Flashing at 75% slower than normal when less than ~2.5kVSKU: n/a -
Uncategorized
Fence Scope Multi Tool
The Fence Scope is a 4 in 1 tool, which helps diagnose problems on your fence to optimize electric fence installation and ensure that the fence continues to operate at ideal levels.There are four operation modes to select from:
• Fence Probe mode –quickly indicates the direction of a fence fault, showing the voltage and current
• Fence energy mode- accurately measures the output energy along the fence. This mode can be used to test the size of the shock the intruder will receive at any point along the fence by simulating the intruder. This helps to ensure that the voltage and the energy is sufficient along the entire fence to deliver an appropriate shock to the intruder.
• Fence scope mode –this can record and display wave forms of the electric fence pulse. Distortions in the wave form (wave shape) generally indicate that there are fence faults.
• Fence noise mode –this shows the amount of electromagnetic interference generated by the fence or energizer. This feature assists in finding cracked or broken insulators, sparks and shorts along the fence.Pouch sold separately.
Specifications
Display (LCD): 128 x 64 pixels, landscape orientation, 1bit/pix colour depth
Operating Temperature: -10 C to +50 C
Battery Type: 9V alkaline, 6LR6 / PP3, 50 hours typical battery life (without using backlight)
Size: 102 mm W x 50 mm H x 192 mm L
Weight: 298g (with battery), 251g (without battery)SKU: n/a -
-
Uncategorized
Hammer Drive Zinc Alloy 6*50 (100 pack)
The hammer drive with zinc alloy is ideal for securing the Nemtek brackets onto a wall.Features:
• Hammer drive anchors are ideal for coastal areas
• Sizes available for most of the Nemtek bracketsSpecifications
Material: Zinc alloy
Size: 6mm x 50mm
6mm x 55mmSKU: n/a -
Uncategorized
HT Cable Black 4 Core/100m Slimline
The S-Series high voltage cable is used as a lead out cable from your energizer to the fence and for all other insulated high voltage transmissions. These high voltage cables can be used with all the Nemtek galvanised wires. They are available in single core or multi core contraction.
Features
• Slimline designed for ease of installation and an aesthetically pleasing look
• Cable is made up of tinned copper stranded wires for more flexible and ease of use
• The multi core S-Series reduces installation timeSpecifications
Material: UV stabilised double insulated
Tinned copper stranded wiresSKU: n/a -
Uncategorized
HT Cable Black Stainless Steel S316
The S-Series high voltage cable is used as a lead out cable from your energizer to the fence and for all other insulated high voltage transmissions. These high voltage cables can be used with all the Nemtek galvanised wires. They are available in single core or multi core contraction.
Features
• Slimline designed for ease of installation and an aesthetically pleasing look
• Cable is made up of tinned copper stranded wires for more flexible and ease of use
• The multi core S-Series reduces installation timeSpecifications
Material: UV stabilised double insulated
Tinned copper stranded wiresSKU: n/a -
-
Uncategorized
Sliding Gate Contact Universal Bracket
Features:
• Heavy duty design to secure the gate connect in place during continuous operation
• supplied with adjustable screws for finer settings
• Hot-dip galvanised finish can cope with most environmentsSpecifications
Finish: Hot dip galvanised
Weight: 1.15kgSKU: n/a -
Uncategorized
Solid Stainless Steel Wire
Solid stainless steel offers a higher resistance to corrosion environments and a longer life span on the fence. The 316 grade is the wire of choice for highly corrosive coastal areas.Features:
• Stainless steel grade 304 can be used in most corrosive environments and near the coast (5km)
• Stainless steel grade 316 can be used in most harsh corrosive environments and on the coast .
• High in tensile strengthSpecifications
AISI 316 Stainless Steel
Tensile Strength, Ultimate: 580 MPa (58kg/mm2)
Tensile Strength, Yield: 290 MPa (29kg/mm2)
Elongation at Break 50 %AISI 304 Stainless Steel
Tensile Strength, Ultimate: 510 MPa (50kg/mm2)
Tensile Strength, Yield 215 MPa (21kg/mm2)
Elongation at Break 70%SKU: n/a -
-
Uncategorized
SQ 20*20*1.6mm Bracket
Nemtek brackets are made to a high standard to maximize security and ensure long life in the field. The level of security achieved is directly affected by the choice of bracket, the number of wires forming the electrical barrier, and the distance between the brackets. Nemtek offers a large range of brackets to suit most wall types and applications. They are made from steel and are finished in a high-quality outdoor powder coating, or are hot-dip galvanized for coastal conditions. Our factory can manufacture different types of designs and finishes on request.Features:
• Straight and angled
• Multiple wire options; 6 wire (995 mm), 8 wire (1195 mm), or 10 wire (1395 mm) long
• Hot dip galvanized or hot-dip galvanized and powder-coated finish
• Associated insulator: Jurassic insulator slotted and non-slotted.
• Ideal for coastal useSpecifications
Material: 20mm X 20mm X1.6mm
Finish: Hot-dip galvanized or hot-dip galvanized with powder coating
Colour powder coated: Back or WhiteSKU: n/a -
Uncategorized
Stay & Lug Bracket 750mm HDG
Stay & Lug Bracket 750mm HDG
The stays have a built in lug included. The stay is used to support the wall to brackets when there is a end or corner.
Features:
• Available in powder coated (PC) black and white or in a hot dip galvanised (HDG) finish.
• 600mm and 750mm lengths
• 600mm up to 6 wires bracket support
• 750mm up to 8 wires bracket supportSpecifications
Finish: Powder coated black or white
Hot dip galvanised
Diameter: 8mmSKU: n/a -
Uncategorized
Stay Sleeve 750mm Black
Insulated stay sleeve protect the wire from arcing onto the stay and causing false alarms. They can be used with the 8mm stay and also a 10mm stay.Features:
• Easy to slide onto the stay
• Can be cut to size a required
• Eliminates false alarmsSpecifications
Material: UV stabilised plastic
Size 8mm stay: 600mm and 750mmSKU: n/a -
Uncategorized
TANDEM RATEL(S) 3KW HD ELEC 46cm
For commercial use, contractors and large gardens of 1 acre and over.
- 3kW Motor Heavy-Duty Electric Motor
- 55 Litres Grasscollector
- 460 mm cutting width
- Heavy Duty 46cm Bar Blade
- Steel Heavy Duty Contractor Chassis
- Twin bearings on each wheel
- Reinforced Handles
- Steel H/adjuster System
SKU: 9100-420010 -
Uncategorized
Warning Sign Nemtek
Warning signs must be placed along the fence line to warn of the existence of an electrified fence. These must be placed at 10m intervals along the fence, at gate ways or whenever there is a change of direction. Wire clips on the warning sign reduce installation time.Features:
• IEC 60335-2-76 compliant design
• Custom versions are available on request in both screen or pad printSpecifications
Material: UV protected for long life
SKU: n/a
